Water spots, limescale, rust stains, and mineral deposits don't stand a chance against Purify. This advanced gel-formula water spot and stain remover from Carbon Collective is engineered to dissolve even the most stubborn bonded contamination from paint, glass, bare metal, and ceramic-coated surfaces — all without the need for aggressive scrubbing.
More Than Just a Water Spot Remover
Most water spot removers do one job. Purify does five. Its acid-blend and surfactant formula targets a wide range of contamination that builds up over time and resists standard washing:
- Water spots & watermarks – hard mineral deposits left by tap water, rain, and sprinklers
- Limescale – stubborn calcium build-up around trim, badges, and glass
- Rust stains – iron and tannin-based discolouration on paint and metal
- Road salt residue – corrosive winter grime that hides in panel gaps and around badges
- Organic matter & biological build-up – dirt, algae, and grime that clings to protected surfaces
Safe on All Your Surfaces
Purify's balanced pH 2.7 formula is strong enough to cut through bonded contamination yet safe for use on painted surfaces, glass, polished and bare metal, and — critically — ceramic coated finishes. It won't strip or damage your protection; it clears the contamination blocking it, so your coating can perform at its best again.
No Scrub. No Fuss. Real Results.
With Purify, the product does the hard work. Spray it onto a microfibre cloth and wipe — for most watermarks and light staining, that's all it takes. For heavier contamination, apply directly to the surface, leave it to dwell for 30 seconds, and wipe clean. No heavy-handed scrubbing, no risk of marring your paintwork.
It's also perfect for those awkward areas that build up grime over time — around badges, in panel gaps, around fuel caps, and along rubber trim lines where a standard wash never quite reaches.
Specification:
- Size: 500ml
- pH Level: 2.7
- Formula: Advanced acid-blend gel with surfactants
- Safe on: Paint, glass, metal, ceramic coated surfaces
How to Use:
- Wash the vehicle thoroughly before use
- Shake the bottle well
- Apply 2–3 sprays onto a clean, soft microfibre cloth
- Gently wipe the affected surface until stains are removed — reapply if needed
- For heavy water spots or staining, apply Purify directly to the surface and allow to dwell for 30 seconds before wiping
- Finish by rinsing with clean water or wiping with a damp cloth
⚠️ Do not use in direct sunlight or on hot surfaces.